DKU 5 USB TO SERIAL DRIVER DOWNLOAD

In reply to scoobyman’s post on March 22, The rest of this page describes how to connect up your internal serial port. Thanks again and maybe till some other time. Servet says Makes sense, thanks for the tip! Please post back with your results.

Uploader: Vudokasa
Date Added: 22 September 2017
File Size: 42.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 68066
Price: Free* [*Free Regsitration Required]

I love big hard drives…dig around enough and you can find the cruft of ages. I used screen as my serial communications program. January 12, at 1: Victor March 15, at 2: People usually did it with a 3rd party chip. I think the manufactures buy these cable based usg how cheap they dk with little concern for how many wires they have. To do this cut the cable a couple of inches 5 cm from the phone connector.

Low Cost (1,85€) USB to RS LVTTL Serial Cable – The BiT Bang Theory

Electronics — jethomson 5: Then we attached the connector for the three wires for easy connection to the Seagate, get fo square type. The LED dki blink a couple times. Thanks for marking this as the answer. Old mobile phone cable to TTL serial cable 1. Twist the RxD and TxD lines together. Unfortunately i have no good experience with cheap chinese DKU-5 but i have found CA cable the best for me… It has only three wires.

Related Drivers  FARALLON SKYLINE MAC DRIVER

Thanks again and maybe till some other time.

Thanks for sharing how to do it. These cables vary a good bit.

What version of pc suite supports a dku-5 usb cable ?

Both were physically moleded around the circuit board so I managed to break the wires. Unplug the USB cable. You are commenting using your Twitter account.

You could try it and see, but you might smoke it. My cable appears to have been constructed differently — see pics: Make sure none of the wires are touching one another!

What version of pc suite supports a dku-5 usb cable ? – Microsoft Community

I have no idea how you can figure out if your RxD pin is 5V tolerant. November 26, at 8: I was however unable to get it to recognise the cable and looking on EDA Board appears a special […].

It worked, but without auto-reset it is a little hard to press reset perfectly.

The PL cables definitely get the job done though. Arthur Vicente Ribacki Says:.

Related Drivers  HP C5183 DRIVER FOR WINDOWS 7

In what words should I describe it when doing a Google search? You are commenting using your WordPress. Did you find this post helpful? You will find a PCB with the chip on it. You can follow the question or vote as helpful, but you cannot reply to this thread. I’m afraid I cannot use the “hardware installation” option since I don’t know what directory the new drivers will be written to.