GTCO ROLL UP II DRIVER

Roll-Up II 26 2. All other products and company names are the trademarks or registered trademarks of their respective owners. The perfect tool f LCD Display featuring 16 characters x 2 lines 2. Cnc, Cad, and Cutting Ind Hold or temporarily tape the card in place to keep it from moving during the configuration process.

Uploader: Kajibar
Date Added: 21 October 2008
File Size: 66.54 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 4440
Price: Free* [*Free Regsitration Required]

To select Point Mode: Roll-Up II 50 Binary formats use the high order bit in each byte as a synchronization bit. The table below describes the kinds of tones you may hear while operating the digitizer.

Warranty Service Procedures 1. Roll-Up II 20 Example: Click ‘Point 1’ – you should hear continuous beeping. There are two kinds of flow control: The previous Remote Commands section contains detailed information about remote commands.

Use the small removable template, which came with the digitizer.

GTCO Roll Up Digitizer

Be prepared to discuss the observations you made while troubleshooting. Tell us what’s missing. Page 24 Roll-Up II 24 retained even if the unit is powered off or reset.

Related Drivers  GIGABYTE 78LMT-S2P ETHERNET DRIVER DOWNLOAD

There is a crease accross part of the mat. You can define certain pushbuttons ji your transducer to represent information that is relevant to your task.

Gtco Roll Up Digitizer | eBay

Roll-Up II 5 factory-supplied shipping tube. Send the command one character at a time. Install only the drivers necessary for Roll-Up II to work with the application software. This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. Place the card in the active area of the tablet the entire menu must be in the active area.

The Roll-Up II is now ready to accept commands.

GTCO Roll-Up II – Users Guide User Manual

Is This Content Helpful? Digitizer and software used by California commercial concrete contractor. Roll-Up II 33 Character Format and Baud Rate Character format and baud rate govern how bits are assembled to form characters and the speed of transmission. BI Command causes coordinates to be transmitted in binary format.

Notice Some states and provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you. Pushbutton codes and where they appear in coordinates are described in the Advanced Programming Information section.

Related Drivers  SAMSUNG ML-2010R PRINTER DRIVERS FOR WINDOWS 7

The connector is keyed and will fit only the correct jack. North Carolina Sold by: RS The Reset command will reset the Controller to the last known configuration, clearing all previous commands sent to the Controller.

RD Rlll command causes the Roll-Up II to examine the attached tablet and send the results to another device for display.

Roll-Up III Tech Specs – GTCO

Or point ii to the URL where the manual is located. Read Tablet Diodes Code: This warranty gives you specific legal rights, and you may have other rights, which vary from state to state, or province to province. Data bits represent the actual data being sent from one device to another. To select Line Incremental Mode: Cha racter For mat and Baud Rate.